These Oil Pressure Regulators Suit Mazda Rotary Engines. The oil pressure will be increased to 95 PSI (Comes with 95 PSI Spring Fitted) Note - This regulator can be fitted with our 120 PSI spring - the end cap screws off allowing different springs to be fitted.
More Information

These Oil Pressure Regulators Suit Mazda Rotary Engines. The oil pressure will be increased to 120 PSI (Comes with 120 PSI Spring Fitted) Note - This regulator can be fitted with our 95 PSI spring - the end cap screws off allowing different springs to be fitted.
More Information

This Spring is used in the older style Mazda Rotary Oil Regulators (from Twin Dist. to 3B Single Dist.) to increase the oil pressure to 95 PSI.
More Information

This Spring is used in the older style Mazda Rotary Oil Regulators (from Twin Dist. to 3B Single Dist.) to increase the oil pressure to 120 PSI we do not recommend this for Turbo Motors .
More Information

This is the Mazda Factory Race Oil Pump to suit eary Rotary Engines (3B & R5 Motors)
More Information

This Block off Bung is used to replace the Heat Pellet (Oil Thermostat) in the front of Mazda Rotary Turbo E/Shafts, allowing full oil pressure all the time & reduce the risk of running low oil pressure.
More Information

This Sump Suits Mazda Rx7 SI,II & III when fitting A 13B Motor
More Information

This Oil Pick Up Suits Both Mazda 12A & 13B Rx7 Si Sii & Sii Sumps
More Information

Mazda Rotary Engine Oil Pick Up Gasket
More Information